Larson Electronics Solar Control System - 80 Amp Rating - 24V DC - NEMA 3R Enclosure

Made in the USA *PLEASE NOTE: ANY FREE SHIPPING OFFERS DO NOT APPLY TO MASTS OR TRAILERS* The SCS-80A-24-V1 solar controller and charging station provides operators with an effective way to manage off grid solar charging systems. In this 24 volt system solar control system, each panel is terminated with a fused combiner box with a single lever action cut-off switch. With the switch set to the ‘on’ position, the combiner box passes power to the 80-amp capacity Outback Extreme charge controller. The SCS-80A-24-V1 solar job box uses the Outback Extreme series since it standard temperature threshold is more than 160 degrees Fahrenheit, due to its integrated heat sink and fan assembly. Oddly enough, most charge controllers aren’t rated past 104 degrees Fahrenheit despite the fact the will always be close to direct sunlight. In the summer time in Texas, our fabrication shop is normally warmer than that, so this solar light tower uses a charge controller that would support the southern heat. We improve on that capability by shading the charge controller and adding additional air flow from the exhaust of a 1400 CFM component cooling system. Component Control Center In order to ensure that the 50% threshold on the batteries is controlled, this solar trailer includes a system of min/max voltage sensors and relays that monitor the voltage produced by the batteries and will automatically shut off power distribution when the battery capacity falls below 50%. This protects the batteries from failure. We also include ground fault protection and an Outback Mate 3 monitoring system to track and log all activities related to the charger controller and battery health. In the event there is an issue with the solar trailer, the SD card can be removed from the Mate 3 and sent to Larson Electronics for analysis. All the electrical components, including the combiner panel, charge controller, over/under battery monitoring and ground fault isolation are encapsulated in a Nema 3R job box that is bolted to the trailer. Since most of these components are not rated for high heat, our component cooling system circulates air within the job box at 1400 CFM when the ambient temperature exceeds 90 degrees Fahrenheit. The component control center also includes a terminal block so that customers can mount additional electronic gear without interfering with the charging systems. The job box that contains the component control system includes locks for security purposes. Customization Larson Electronics is a manufacturer of light tower systems and can customize systems to meet custom requirements. Contact us at 888-325-4448 [email protected] to learn more. Specifications / Additional Information SCS-80A-24-V1 Solar Charger Control System Features Panel protection: Fused combiner box System Protection: Battery over/under and ground fault System Voltage: 24 Volts Special Orders- Requirements Inverter: None Contact us for special requirements Dimensions: Toll Free: 888-325-4448 Weight: E-mail: [email protected] Down to Purchase