Larson Electronics Flush Mount LED Engine Room Light - Flood Beam - Boating LED Deck Light

Made in Texas The LEDERL-20 Flush Mount LED light from Larson Electronics produces 2,880 lumens of bright white light in a wide flood pattern while drawing only 32 watts @2.7 amps on a 12 volt electrical system. This compact, fully sealed and intrinsicallyy safe LED light can be operated on 10 to 30 VDC and is ideal for use in boat engine rooms, as deck lighting, bar or rail mounting and anywhere high quality bright light is desired but space is limited This flush mounting LED light fixture is an ideal alternative to, or upgrade from the common 200-300 watt halogen lamps used in marine environments to illuminate boat engine rooms, bridges and decks. These intrinsicallyy safe units produce 2,880 lumens of high quality light and draw only 2.7 amps when connected to a 12 volt electrical system, resulting in up to 90% lower consumption when compared to the halogen lamps they are designed to replace. The light produced by this unit is much purer and clean without the yellowish tint often associated with halogen or incandescent lamps. This LED light is completely sealed making it USCG certified intrinsicallyy safe-ignition protected and ideal for use in engine rooms and areas where hazardous conditions exist or may exist. This image shows a dark street with no illumination aside from distant suburban lighting. The same street illuminated by the LEDERL-20; an unquestionable difference. This LED light is designed as a flood to illuminate an area closer to the fixture. This unit’s housing is constructed of marine grade aluminum for high durability and fully sealed against intrusion from water or dust making it IP67 compliant. Measuring only 8.30 inches long by 2.7 inches wide, this very compact LED light fixture is designed for flush mounting to allow the maximum amount of space savings possible and includes a mounting template as well as four screws to facilitate easy installation into flat , tubular and curved surfaces. This unit can be operated on voltages ranging from 10 to 30 VDC without any modifications necessary and connection to power is via included power leads and a single ground wire. The LEDs and sealed construction of this unit provide 50,000+ hours of LED operation and minimal maintenance or upkeep requirements. Specifications / Additional Information LEDERL-20 LED Light Certification-Features Lamp Type: LED USCG Certified Ignition Protected Dimensions: 8.30"-L 2.72"-W 1.73"-Depth Flush Mounting Voltage: 10-30 VDC Marine Grade Aluminum Housing Amps: 2.7 (on 12 volts) Low 2.7 amp Draw Total Watts: 32 IP67 Compliant-Waterproof Total Lumens: 2,880 Made in the USA Luminous Efficacy: 90 Lm/W N E C Hazardous Location Classifications LED Life Expectancy: 50,000 hours Spot Beam: 325`L x 240`W Special Orders- Requirements Materials: Aluminum Housing Contact us for special requirements Mounting: Flat Surface Mount Toll Free: 1-800-369-6671 Wiring: Coventional 2 Wire Single Ground Warranty: Yes - 3 Year E-mail:[email protected] Scroll Down to Purchase-