Larson Electronics Emergency Ballast for EMG LED Light Fixtures

The Larson Electronics XXL-EMG-20W-LVS-V1 Emergency Backup Ballast works in conjunction with a LED fixture to create an emergency lighting system. This Ballast operates a maximum load of 18W at unity power factor. It allows the connected fixture(s) to be on, off, switched or dimmed without affecting emergency operation. Each unit consists of a high-temperature nickel-metal hydride, charger and electronic circuitry in one steel case. The XXL-EMG-20W-LVS-V1 provides power to the input side of the fixture, including the ballast, and can be used with indoor or outdoor emergency fixture applications. The XXL-EMG-20W-LVS-V1 supports emergency illumination for a minimum of 90 minutes. At a maximum of 18W at unity power factor, the XXL-EMG-20W-LVS-V1 will provide input power to ballasted lamp supporting it at 100% of the AC rated output throughout the 90-minute emergency illumination period. Upon failure of normal power, the ballast instantly begins providing emergency power to the connected lighting load for a minimum of 90 minutes. A solid-state low voltage disconnect circuit protects the inverter battery from severe damage by deep discharge during prolonged power failures. When normal power is restored, the XXL-EMG-20W-LVS-V1 automatically returns to charge mode. The battery capacity is fully restored in 24 hours. The ballast does not affect normal fixture operation and may be used with a switched or unswitched fixture. It can be installed in close proximity to the fixture or remote from the fixture (up to 250 feet). Emergency lighting shall be provided by using a standard fixture equipped with the Larson Electronics XXL-EMG-20W-LVS-V1. Each unit consists of a high-temperature, maintenance free nickel-metal hydride battery, charger and electronic circuitry contained in one 11 x 2.8" x 2.85" metal case. Solid-state indicator lights signal operational status. The XXL-EMG-20W-LVS-V1 unit shall be capable of powering any low voltage LED lighting fixture rated at a maximum of 18 watts for a minimum 90 minutes regardless of local switch position. The XXL-EMG-20W-LVS-V1 shall allow the connected fixture(s) to be on, off, switched or dimmed without affecting emergency operation. The XXL-EMG-20W-LVS-V1 unit shall exceed emergency standards set forth by the current NEC. It shall be UL Listed, suitable for damp location. Specifications / Additional Information XXL-EMG-20W-LVS-V1 Emergency Backup Ballast ETL Certified ETL Listing: United States Factory or Field Installation (Indoor and Damp) Dimensions: 11" W x 2.8" L x 2.85" H Temperature Rating (Ambient): -40¡C to +50¡C Weight: 5 Lbs Made in the USA AC Input Voltage: 120/277 VAC (Auto Select), 60hz AC Input Current: 90 mA AC Input Power Rating: 9.5W Maximum Load Power: 18W (Including AC Ballast/Driver) Output Current: 24V DC Illumination Time: 90 Minutes Test Switch: Single Pole (Momentary) Battery: Cold-Temperature, Maintenance Free NiMH Battery Life: 7 to 10 Year Life Expectancy Special Orders - Requirements Battery Capacity: 3800 mAh Contact us for special requirements Recharge Time: 24 Hours Phone: 1-800-369-6180 Charging Indicator Light: LED Fax: 1-903-498-3364 Special Features: Fused Output Load Connections E-mail:[email protected] Scroll Down to Purchase-