Larson Electronics 150 kVA Power Distribution System - 480V 3 Phase - Ten ADR1044 100A Outlets

Made in the USA The Larson Electronics MGS-150KVA-480-10X100A heavy duty power transformer substation series converts 480V three phase electrical current to single phase 120V AC and 240V (208Y) AC. This unit provides operators the ability to safely tap into and distribute 480VAC power from a variety of sources including generators and direct grid power. This model is designed to support both linear (motor) and non-linear loads (lighting, computers, etc). For that reason, we deliver 120V and 208Y on the secondary and provide a neutral. *PLEASE NOTE: ANY FREE SHIPPING OFFERS DO NOT APPLY TO POWER DISTRIBUTION PANELS, TRANSFORMERS, OR SUBSTATIONS* The MGS-150KVA-480-10X100A power distribution substation provides a safe and effective way for operators in industrial settings to tap into and utilize power sources independently of the work area. This unit provides an effective power source for operators performing plant turnarounds, maintenance and cleaning in hazardous areas, equipment installations and repairs and any activities requiring an alternative to native power sources. This unit is designed to operate with a 480V, 3 phase primary which it then steps down to 120V single phase and 240 (208Y) VAC. This transformer provides secondary power via 4 GFCI protected 120V receptacles and ten ADR1044 100 amp, 4 wire, 4 pole receptacles for 3 phase 208Y. The operator provides line-in cord that connects to a 400 amp fused ON/OFF disconnect switch which controls current to the 150 KVA, 480 Volt, 3 phase transformer with Nema 3R configuration. The transformer is mounted to a 1/8” thick diamond plate and the distribution assembly is mounted onto a rugged 2 inch square carbon steel frame with 3" X 6" X 3/8" rectangular carbon steel skid pockets and a top located lifting eyelet to allow easy transport. This unit is Nema 3R configured and ideal for use in applications including but not limited to, plant maintenance, hazardous location operations, welding stations, shows and exhibits and marine applications. This series of portable power distribution can support both motor and lighting loads. Larson Electronics is a manufacturer and as such can build power distribution susbtations to your specifications. Although we carry several models of power distribution systems, we can deliver custom ordered units almost as quickly as our prebuilt units. If this model does not meet your needs, please contact us at 888-325-4448 [email protected] Specifications / Additional Information MGS-150KVA-480-10X100A Power Distribution System Ratings Line In: 480 VAC Three Phase (operator provides cord) UL 1640 Portable Power-Distribution Equipment Transformer KVA: 150 NEMA 3R Indoor or Outdoor Use Line Out: 120VAC - 208Y VAC Made in the USA 120 VAC Outlets: 4 X 120V 20amp GFI 208Y Outlets: 10 X 100 amp ADR1044 Protection: GFCI Outlets, Onboard Circuit Breakers Mounting: Skid and Lifting Eyelet Equipped Steel Frame Panel: 200 amp 3 phase Weight: 650 pounds Special Orders- Requirements Dimensions: 48"W X 40"D X 56"T Contact us for special requirements Disconnect: 400 amp fused Toll Free: 888-325-4448 Breakers: 10 X 100 amp 3 phase & 4 X 20 amp E-mail: [email protected] Larson Electronics manufacture a wide variety of custom power distribution systems. The pictures displayed for this unit are a general representation of form factor and may not accurately represent this exact configuration in every detail due to being custom builds. The specifics for this configuration are listed in the specification table and one-line diagram. *All grounding shall comply with state and local codes and meet the minimum requirements of the National Electronic Code section 250* Scroll Down to Purchase