Larson Electronics *RENTAL* Class 1 Division 2 Emergency Fluorescent Light - Corrosion Resistant

Made in the USA The Larson Electronics RNT-HALP-EMG-48-2L Hazardous Area Fluorescent Light Fixture is U.S./Canada U.L. approved Class 1 Division 2 Groups A, B, C and D -NRTL Certified to UL 1598A listed, has a T4C temperatue rating and is specifically designed to handle the rigors of wet and corrosive marine environments. This fixture is equipped with an added battery backup providing 90 minutes of emergency runtime.This unit is for rentals. Please The RNT-HALP-EMG-48-2L hazardous area fluorescent light fixture is designed for use in wet areas and saltwater-marine environments where corrosion resistance is critical to equipment longevity and safety. This Class 1 Division 2 rated fixture is constructed of non-corrosive materials including a polyester housing reinforced with glass fiber, a poured in gasket for reliable sealing and an impact resistant acrylic diffuser. Corrosion resistant stainless steel latches secure the lamp cover to the housing and provide a firm lock against the poured in seal to prevent drips and water intrusion. This fixture is NRTL Certified to UL 844 rated and Class 1 Division II, Groups A, B, C, D approved. The HALP-EMG-48-2L also carries a NRTL Certified to UL 1598A outdoor marine rating and meets US Coast Guard specifications. This fixture is NRTL Certified to UL 844 rated and Class 1 Division II, Groups A, B, C, D approved. The HALP-EMG-48-2L-T12HO also carries a NRTL Certified to UL 1598A outdoor marine rating and meets US Coast Guard specifications. This fluorescent light works, mounts and is wired like our HALP-48-2L explosion proof fluorescent light fixtures. The main difference is that we add a battery backup unit that adds emergency light functionality to the fixture. This hazardous area emergency light will run the standard NRTL Certified to UL suggested 90 minutes after power is lost. The light recharges the battery once electrical power is restored. Standard configuration includes a single emergency ballast that will run a single lamp at 900 lumens for 90 minutes. The battery backup unit includes a switched leg for turning the light fixture on/off without kicking the unit into emergency mode. NOTE ON LAMPS: This fixture comes equipped with F54-T5/841/HO – 54 Watt lamps producing 5,000 lumens per bulb, a 4100 Kelvin color and a 20,000 hour rated service life. Standard Flange Brackets: Flange type stainless steel mounts attached at each end of the fixture enables it to be simply secured to any surface. The mounts provide some shock absorbency protection while enabling the user to simply mount the fixture with the through-hole taps that protrude on each side of the fixture. The mounting holes are 36 9/16 inches on center apart along the top of this hazardous location light. The mounting holes are 7 inches on center across the top of the light. Suggested Applications: The RNT-HALP-EMG-48-2L is designed for marine wet and damp locations, where corrosion resistant fluorescent lights are required. This includes petrochemical facilities, lubrication pits, oil drilling rigs, crew quarters, solvent/cleaning areas, water treatment areas, processing plants and marine loading docks. Made in USA Quality Lamp Options 1. Each unit dialectrically tested.2. Fixture arrives assembled and lamped to reduce installation time and cost. Flange type stainless steel mounts attached at each end of the fixture enables it to be simply secured to any surface.3. Fixture housing constructed of glass fiber reinforced polyester.4. Relamping done via 6 stainless steel snap locking latches, which enable the operator to remove the door and access the lamps.5. Lamp cover-diffuser constructed of high impact acrylic for corrosion resistance and lamp protection.6. 1/2" or 3/4", threaded access hole for wiring conduit. F48-T12/HO – 4050 lumens per bulb, 12,000 hours life, 4100 Kelvin color Specifications / Additional Information RNT-HALP-EMG-48-2L Hazardous Area U.L. Ratings UL Listing: United States - Canada Class 1 Division 2, Groups A, B, C, D Lamp Type: Fluorescent NRTL Certified to UL 844 Dimensions: W-8.25 " L-52 " H-7"NRTL Certified to UL 1598A Marine Type (Salt water) Weight: 8 Lbs NRTL Certified to UL 924 - Failsafe battery backup Voltage: Multi- 120V-60hz 220V-50hz 240V-60hz 277V-60hz UL Listed for Canada Low Voltage Optional: 9-32VDC Meets USCG Specs Total Watts: 96 watts T4 Temperature Rated Total Lumens: F48-T12/HO 8,100 Switch Leg for Powering Light On/Off Luminous Efficacy: 83 Lm/W Lamp Life Expectancy: 20,000 Hours Color Temp: 4100K- CRI-75 Efficiency: 98 Lumens per Watt Ambient Operating Temp Range: -40¡ C to +70¡ C Operating Temp Range: T4C Rated Battery Backup: 90 Minute Runtime Surface Mounting: (2) Flange Type Aluminum Brackets Pendant Mounting: (2) 1/2" or 3/4" Threaded NPT Hubs on Either Side Special Orders- Requirements Wiring Hub: (2) 1/2" or 3/4" Threaded Hubs Contact us for special requirements Rental Type: Monthly, Weekly, Daily Toll Free: 888-325-4448 U.L Approval: U.S Certificate Canada Certificate Meets US Coast Guard specifications. E-mail: [email protected] Rentals: In an effort to cut back on contracts and various other paper work, Larson Electronics processes rentals like orders until the product is returned. This means, we will charge the customer for the product total and credit back the difference once the fixture is returned. Weekly and Monthly terms are available. Customer must pay shipping to and from the destination. Please contact us at (903) 498-3363 for further information if required.Rental Prices for the RNT-HALP-EMG-48-2L:Monthly...$285.00 USDWeekly...$190.00 USD