Larson Electronics Explosion Proof Distribution System - 120V - (4) 20A Group B Outlets - 20A Disconnect - APJ3385-S4 c

Made in Texas This explosion proof distribution system enables operators to power up to four 120V explosion proof tools or equipment via a single grid access service, with circuit breaker protection. *PLEASE NOTE: ANY FREE SHIPPING OFFERS DO NOT APPLY TO POWER DISTRIBUTION SYSTEMS OR SUBSTATIONS* Line-in power is provided by an APJ3385-S4 connector and a 10/3 SOOW cable from the 120V power source to a Killark EXB-886 N34 Class 1 Division 1, Groups B, C, and D circuit breaker enclosure with an EXH1A6 circuit breaker handle and 20-amp circuit breaker. The breaker enclosure protects ENRB22201 two gang 20-amp feed through receptacles and ENRB22201 two gang 20-amp dead end receptacle. One sealoff is installed on the input side of the feed-thru double gang receptacle device box, and one sealoff is installed between the feed-thru and dead end receptacle device boxes for Group B compliance. EXB-886 N34 Class 1, Division 1, Groups B, C, and D Circuit Breaker Enclosure Click Photos to Enlarge ENRB2201 20 Amp Class 1, Division 1, Groups B, C, and D Receptacles (FT & DE) The entire assembly is mounted on a powder coated aluminum frame supported by 1-inch square tubing. Portability is provided by dual polyurethane wheels. The entire assembly can be easily tilted back and moved around. The cart features a built-in front mounted cord wrap for manual cable management of the 50` line-in cable during storage and transportation. Larson Electronics is a manufacturer of power distribution systems and can custom build power distribution systems to your requirements. If this unit does not meet your needs please contact 888-325-4448 [email protected] to discuss your specific requirements. Specifications / Additional Information EPSB-MGL-4X120.20A-V2 Explosion Proof Power Distribution System Amps: 20 Line In Voltage: 120V Ratings: Class 1 Division 1, Groups B, C, D Line-in Cable: 50’ 10/3 SOOW Certifications: UL 1640 Line-in Cord Cap: APJ3385-S4 Circuit Protection: C1D1 EXB-886 N34 Enclosure with EXH1A6 circuit breaker handle and 20A circuit breaker Secondary Receptacles: ENRB22201 FT and ENRB22201 DE C1D1 Special Orders- Requirements Form Factor: Powder coated aluminum dolly cart with (4) polyurethane wheels Contact us for special requirements Dimensions: 34”W X 30”D X 56”H Toll Free: 888-325-4448 Weight: 200 pounds Shipping Weight: 250 pounds E-mail: [email protected] Larson Electronics manufacture a wide variety of custom power distribution systems. The pictures displayed for this unit are a general representation of form factor and may not accurately represent this exact configuration in every detail due to being custom builds. The specifics for this configuration are listed in the specification table and one-line diagram. *All grounding shall comply with state and local codes and meet the minimum requirements of the National Electronic Code section 250* Scroll Down to Purchase