Larson Electronics 4' 2 Lamp Fluorescent Light Fixture - Emergency Battery Backup - T8 Bulbs - Multi-voltage - CID2

Made in the USAThe Larson Electronics HALS-EMG-48-2L-T8 Hazardous Area Fluorescent Light Fixture is NRTL Listed for United States and Canada Class I Division 2 Groups A, B, C and D - NRTL Certified to 1598 listed and ideal for use in industrial hazardous location lighting where wet conditions and chemical/petrochemical vapors may be encountered.***PLEASE NOTE: ANY FREE SHIPPING OFFERS DO NOT APPLY TO THIS LIGHTING SYSTEM***The HALS-EMG-48-2L-T8 fixture is a 4 foot long, 2 lamp, Class I Division 2 Groups A, B, C and D hazardous area fluorescent light and a good choice for use in industrial applications and wet areas. This fixture is T4A temperature rated and comes standard with two F32/841-T8 bulbs. The housing on this unit is constructed of powder coated 18 gauge steel for durability and contains a hinged reflector and ballast tray for easy and safe servicing. The lamps are held in place by spring loaded sockets and protected by a hinged glass door with a 3/16” tempered glass lens which is secured with four turn latches.This fluorescent light works, mounts and is wired like our HALS-48-2L-T8 hazardous location fluorescent light fixtures. The main difference is that we attach an extra Bodine ballast box to the unit that adds the emergency light functionality to the fixture. This explosion proof emergency light will run the standard 90 minutes after power is lost. The light recharges the battery once standard electrical power is restored. Standard configuration includes a single emergency ballast that will run a single lamp at 900 lumens for 90 minutes. For an additional charge, a second ballast can be added to run a second lamp for 1800 total lumens output for 90 minutes. The battery backup unit includes a switched leg for turning the light fixture on/off without kicking the unit into emergency mode.This fixture is multi-voltage capable and can be operated with voltages of 120 to 277V AC. This fixture is IP65 rated water and dustproof and approved for wet and marine locations. This fixture also features multiple 1/2" NPT wiring hubs with two located on top of the fixture and two more located at each end, allowing operators to through-wire multiple units in series or mount the unit with wire through conduit pendant mounts.The HALS-EMG-48-2L-T8 provides operators in hazardous locations with a very durable, reliable and affordable lighting solution for open areas where flammable chemicals and vapors may occasionally be present.Standard Surface Mount Brackets: Each surface mounting bracket is attached on each end of the light and allows the operator to adjust the angle of the entire fixture. Pendant mounts are available for operators who wish to mount these fixtures away from the ceiling surface.Pendant Mounting: This light fixture can hang from the ceiling suspected by rigid pipe. Each fixture is equipped with two 1/2" NPT hubs on either side of the fixture. Operators will bring rigid pipe down to the threaded mounting ups. The wiring is fed down through the rigid pipe to one of the NPT hubs and tied to the fixture`s lead wires to complete the electrical connection. The remaining pendant hub provides support for the opposite end of the fixture.Suggested Applications: Aircraft maintenance, Oil drilling rigs, Refineries, Solvent and cleaning areas, Chemical manufacturing, Waste treatment plants, Gas processing plants.Made in USA QualityLamp Options1. Each unit dialectically tested.2. Fixture arrives assembled and lamped to reduce installation time and cost. Adjustable mounting brackets enable the operator to choose any mounting angle for the fixture, where other models may only offer one or three choices.3. Fixture housing constructed of white powder coated 18 gauge steel.4. Relamping done via 4 turn latches, which enable the operator to unlatch the hinged door and access the lamps.5. Heavy gauge hinged reflector with high gloss reflective finish. Resists dents and corrosion.6. Multiple 1/2 inch, threaded NPT access holes for through wiring. 7. Units can be wired end to end in series.F32-T8/841 – 32 watt, 2950 lumens per bulb, 24,000 hours life, 4100 Kelvin color (Suffix –T8)Specifications / Additional Information HALS-EMG-48-2L-T8 Hazardous Area RatingsNRTL Listed for United States & Canada Class 1 Division 2, Groups A, B, C, DLamp Type: Fluorescent Class 2 Division 2 Groups F,GDimensions: W-16.107" L-52.875" H-5.813" Class IIIWeight: 8 Lbs IP65Voltage:120-277 (optional 347 & 480 on request) Wet Area SuitableTotal Watts: 64 Watts NRTL Certified to UL 1598Total Lumens: 5,900 NRTL Certified to UL 844Luminous Efficacy: 92 Lm/W Switch Leg for Powering Light On/OffLamp Life Expectancy: 24,000 Hours Color Temp: 4100K Ambient Operating Temp Range: -30¡ C to +70¡ C Operating Temp Range: T4A Rated Battery Backup: 90 Minute Runtime 900 Lumens Surface Mounting: Surface Bracket Standard - Pendant Optionals Special Orders- RequirementsWiring Hub: 1/2" threaded 2-On Top 2-On Ends Contact us for special requirementsToll Free: 1-800-369-6671?Intl: 1-903-270-1187Meets US Coast Guard specifications. E-mail:[email protected]