Larson Electronics Emergency Backup Ballast for Explosion Proof LED Light Fixtures up to 10 watts

The Larson Electronics EMGBALL-LED1-10W Emergency Backup Ballast works in conjunction with a LED fixture to create an emergency lighting system. This Ballast operates a maximum load of 10 W at unity power factor. It allows the connected fixture(s) to be on, off, switched or dimmed without affecting emergency operation. Each unit consists of a high-temperature nickel-cadmium battery, charger and electronic circuitry in one steel case. The EMGBALL-LED1-10W provides power to the input side of the fixture, including the ballast, and can be used with indoor or outdoor emergency fixture applications. The EMGBALL-LED1-10W supports emergency illumination for a minimum of 90 minutes. At a maximum of 10 W at unity power factor, the EMGBALL-LED1-10W will provide input power to ballasted lamp supporting it at 100% of the AC rated output throughout the 90-minute emergency illumination period. Upon failure of normal power, the ballast instantly begins providing emergency power to the connected lighting load for a minimum of 90 minutes. A solid-state low voltage disconnect circuit protects the inverter battery from severe damage by deep discharge during prolonged power failures. When normal power is restored, the EMGBALL-LED1-10W automatically returns to charge mode. The battery capacity is fully restored in 24 hours. The ballast does not affect normal fixture operation and may be used with a switched or unswitched fixture. It can be installed in close proximity to the fixture or remote from the fixture (up to 250 feet). Emergency lighting shall be provided by using a standard fixture equipped with the Larson Electronics EMGBALL-LED1-10W. Each unit consists of a high-temperature, maintenance free nickel-cadmium battery, charger and electronic circuitry contained in one 16.6" x 2.8" x 2.85" metal case. Solid-state indicator lights signal operational status. The EMGBALL-LED1-10W unit shall be capable of powering any fluorescent or LED lighting fixture rated at a maximum of 10 W (at unity power factor) for a minimum 90 minutes regardless of local switch position. The EMGBALL-LED1-10W shall allow the connected fixture(s) to be on, off, switched or dimmed without affecting emergency operation. The EMGBALL-LED1-10W unit shall exceed emergency standards set forth by the current NEC. It shall be UL Listed, suitable for damp location. Specifications / Additional Information EMGBALL-LED1-10W Explosion Proof Emergency Backup Ballast U.L. Ratings Listing: United States - Canada Factory Installation (Indoor and Damp) Dimensions: 16.6" W x 2.8" L x 2.85" H Temperature Rating (Ambient): 32 F to 122 F Weight: 3.5 Lbs Total Watts: N/A AC Input Voltage: 120/277 VAC (Auto Select), 60hz AC Input Current: 60 mA AC Input Power Rating: 4 W Maximum Load Power: 10 W Output Current: 300mA (30-36V) or 400mA (10-29V) Illumination Time: 90 Minutes Test Switch: Single Pole (Momentary) Battery: High-Temperature, Maintenance Free Nickel-Cadmium Special Orders - Requirements Battery Life: 7 to 10 Year Life Expectancy Contact us for special requirements Battery Charging Current: 180 mA Phone: 1-800-369-6180 Recharge Time: 24 Hours Fax: 1-903-498-3364 Charging Indicator Light: LED E-mail: [email protected] Scroll Down to Purchase-