Larson Electronics Explosion Proof SPST Starter Switch - NEMA 4X Stainless Steel - 10 Amp Rated - C1D1 C2D1

The Larson Electronics EPS-10A-SPST-N4X Explosion Proof Single Pole Starter Switch is listed Class 1 Division 1 & 2 and Class 2 Division 1 & 2 and provides a safe and secure method for operators to use with contactors and magnetic starters to provide circuit selection and control for motors and equipment in hazardous locations. This maintained starter switch is rated for a maximum of 10 amps, is constructed of a stainless steel body, and carries a NEMA 4X rating. This explosion proof starter switch is ideal for operators seeking a high quality explosion proof starter switch rated for use in hazardous areas designated Class 1 Division 1 and Class 2 Division 1. This explosion proof switch is rated at 10 amps. The entire unit is constructed of stainless steel. This unit is easily wall mounted via integral mounting tabs at two corners of the housing and provides a 1/2" or 3/4" hub openings located on the sides of the housing for running electrical conductors in a feed through configuration. A bushing seal at each conductor opening prevents damage to wiring insulation. This unit is rated to handle electrical loads of 120-277 VAC up to 10 amps and is suitable for use in environments where flammable gases and vapors or combustible dusts and particulates may be present. The EPS-10A-SPST-N4X explosion proof starter switch cover and housing box is constructed of stainless steel with all arcing devices contained within an explosion proof labyrinth switch for the highest protection possible. This design does not require external sealing fittings. Two external mounting lugs provide simple and secure mounting of the unit to walls and flat surfaces. The unit box, switch, and face plate are all included with the product. A 1/2" or 3/4" NPT tapped conduit opening is provided on the top of the unit, providing easy and secure connection to main power line supplies. Suggested Applications: Manufacturing, Industrial, Warehouse, Lighting, Lighting, Wet areas or Locations Where Combustible Dust is Present. Specifications / Additional Information EPS-10A-SPST-N4X Explosion Proof Starter Switch Certifications - Compliance Switch Voltage Rating: 120-277 VAC Class I, Divisions 1 & 2, Groups B, C, D Switch Current Rating: 10 Amps Class I, Zones 1 & 2, Groups IIB, IIA Grounding: Single Internal Housing Ground Screw Class II, Divisions 1 & 2, Groups E, F, G Configuration: Front Switch Class III Hub: 1/2" or 3/4" NPT NEMA 3, 4, 4X Unit Materials: Box/Receptacle - Stainless Steel Insulation: Integral Bushings in Conductor Openings Special Orders- Requirements Mounting: External Mounting Lugs on Body Contact us for special requirements Switch Type: Single Pole SPST Toll Free: 888-325-4448 Fax: 1-903-498-3364 E-mail: [email protected] Down to Purchase-