Larson Electronics Class 1 Div 2 Stainless Steel Bi-Axial Fluorescent Light - 4 Foot 2 Lamp Corrosion Resistant Fixture

Made in the USA The Larson Electronics HALSS-48-2L-BX Hazardous Area Bi-Axial Fluorescent Light Fixture is ETL approved Class 1 Division 2 Groups A, B, C and D - 1598A listed and is specifically designed to withstand high vibration locations and the rigors of wet and corrosive marine environments. Click here to see the LED version of this light. The HALSS-48-2L-BX bi-axial fluorescent light fixture is designed for use in wet areas and saltwater-marine environments where corrosion resistance is critical to equipment longevity and safety. This Class 1 Division 2 rated fixture comes standard with two Bi-Axial 40 watt compact fluorescent bulbs which produce a combined 80 watts of illumination. The HALSS-48-2L-BX is constructed of non-corrosive materials including a stainless steel housing, a poured in gasket for reliable sealing and an impact resistant acrylic diffuser. Corrosion resistant stainless steel latches secure the lamp cover to the housing and provide a firm lock against the poured in seal to prevent drips and water intrusion. This bi-axial fixture is 844 rated and Class 1 Division II, Groups A, B, C, D approved. The HALSS-48-2L-BX also carries 1598A and 595 outdoor marine ratings and meets US Coast Guard specifications. This fixture is designed for heavy duty use in applications where intense vibration and corrosive environments may be encountered. Stainless steel construction, high impact acrylic lamp covers, and a Class 1 Division 2 ETL rating make this light ideal for hazardous locations that require lighting with above average dependability. Standard Flange Brackets: Stainless steel bracket mounts attached at each end of the fixture enables it to be simply secured to any surface. The mounts provide flexibility in setting the angle of the fixture. Three through holes provide sufficient mounting for any environment. Suggested Applications: The HALSS-48-2L-BX is designed for marine wet and damp locations, where corrosion resistant fluorescent lights are required. This lamp is also ideal for locations where heavy vibratory conditions are present. This includes petrochemical facilities, lubrication pits, oil drilling rigs, crew quarters, solvent/cleaning areas, water treatment areas, processing plants and marine loading docks. Made in USA Quality 1. Each unit dialectically tested.2. Fixture arrives assembled and lamped to reduce installation time and cost. Flange type stainless steel mounts attached at each end of the fixture enables it to be simply secured to any surface.3. Fixture housing constructed of 14 gauge stainless steel..4. Relamping done via stainless steel snap locking latches which allow the operator to remove the door and access the lamps.5. Lamp cover-diffuser constructed of high impact acrylic for corrosion resistance and lamp protection.6. 1/2 inch, threaded access hole for wiring conduit. Specifications / Additional Information HALSS-48-2L-BX Hazardous Location Lighting ETL Ratings ETL Listing: United States Class 1 Division 2, Groups A, B, C, D Dimensions: W-9 1/2" L-54 " H-6 3/4" 844 Weight: 35 Lbs 595 outdoor marine Total Watts: 80 watts 1598A Marine Type (Salt water) Voltage: 120V-60hz 220V-50hz 240V-60hz 277V-60hz (24V on Request) Operating Temp Range: T4C Rated -30 C to 70 C Minimum Operating Temp: -30 C Maximum Case Temp: 90 C Beam Angle: N/A Mounting: Flange type stainless steel Special Orders- Requirements Wiring Hub: 1/2 inch threaded Contact us for special requirements Toll Free: 888-325-4448 Meets US Coast Guard specifications. E-mail: [email protected]