Downloads:
4” flat frame-in kits combined with LED module and integral reflector. This is designed for use in non-insulated ceiling. Insulation material must be kept a minimum of 3” from fixture. Provided in high efficacy LED with dimmable driver and the special optical diffusion allows high lumen transmission and light uniformity.
DLED-CFK4 Features
Mounting Frame
- Galvanized steel construction.
- Housing adjusts for ceilings up to 1-1/4” thick.
LED module & Trim
- Aluminum extruded Heat sink designed to facilitate heat dissipation to reduce LED junction temperature for maintaining constant light output, color and life of solid state components.
- Module construction includes LED, heat sink and lens.
- Heavy gauge aluminum reflector anodized in clear, haze, gold, champagne and pewter color finish. Reflectors may provide with black and white milled groove baffle collar.
Junction Box
- Listed for through branch circuit wiring.(Max.8 No 12 AWG 90° branch circuit conductors. (4 in, 4 out)
- (5)1/2” knockouts with true pry-out slots and (4) knockouts with Romex cable clamp.
- Ground wire provided on J-box.
Bar Hangers
- 24” Bar Hangers provide stability and support on joists and T-Bar Grid ceilings.
- Housing can be positioned at any point within 24” joist span.
- Score lines allow “tooless” shortening for 12” joists.
LED POWER SUPPLY
- 10-100% dimmable for 120V electronic low voltage dimmer switches.
- Driver feature power factor >.90, THD <20% and has integral thermal protection to sense over temperature or internal failure.
- Driver mounts externally to the module, allowing future replacement, if needed.
Warranty
- 50,000hr of lamp life.
Listing
- ETL Listed.
- State of california Title 24
